HIGH QUALITY CNC Coil To Coil Peeling And Polishing Line Model:KP16(6-16mm)

Send Inquiry

Product descripation:

The coil to coil production line is to remove the surface decarburization layer,crack and other defects through the uncoiler/(pay off), straightener, peeling machine and polishing machine, make the surface from black wire to bright wire.

Main Parameters:

diameter of raw material	6-16mm
external diameter of coil	1500mm
internal diameter of coil	800mm
The height of coil	1000mm
weight of coil	≤ 1T
hardness of raw material	HB320
Raw material tensile strength	≤1000Mpa
raw material	Stainless Steel
environmental temperature	8-45℃
humidity	20-92 %
altitude	＜1000m
voltage	415V,3-phase landing
frequency	50 Hz +2% Hz
atmosphere pressure	5bar=0.5MPa
water pressure	3-4 bar = 0.3~0.4MPa
highest water temperature	≤35℃

Brief introduction of production line:

The coil-to-bar production line removes the surface decarburized layer and crack and other defects etc. from the coil through coil opener,straightening, centerless lathe (peeling machine),polishing and pre-bending and recoiler to achieve the transformation from black coil to bright coil.

Process flow drawing and layout drawing of production line

16Coil opener(Φ6-16mm)→16 Horizontal&vertical straightening machine(Φ6-16mm)→WXC30S peeler(Φ6-16mm)→hydraulic clamp mechanism→16 hub straightening machine→hydraulic clamp mechanism →Pm20 double head belt polishing machine→ hydraulic clamp mechanism-- pre-bending device(Φ6-16mm)→16 recoiler(Φ6-16mm)

Description：(1)for material with diameter of 6mm - 16 mm: Lift the coil into the pay off device with crane, Manually pull coil straight into 16 horizontal & vertical straightening machine, after straightening, the wire rod will go through the wire will go into WXC30S CNC peeling machine,after peeling, go into 16 pre-bending machine through clamping device, and then enter the 16 recoiler in coil.